Saturday, May 28, 2011

Re: [MW:11173] pittings on surface of Shell

vessel is newly consturcted. there is no problem regarding thickness. corrosion allowance is 3 mm.
Regards
On Sat, May 28, 2011 at 7:36 AM, Suresh <bobsuresh24@gmail.com> wrote:
Hii,
 
You should mentioned below info requirement prior to take any decision .
 
1. How long period in service .
2.What is previous Corrosion allowance as Inspection was carried out .
3.you should mentioned in what area to be taken under serious consideration and how much  depth in major areas.
 
Thank you
 
Suresh

On Fri, May 27, 2011 at 12:44 PM, asad azmi <azmiasadayub@gmail.com> wrote:
Dear All,
 
Greetings.
 
Pittings (not more than 0.5 mm in depth) observed on the surface of a shell of a Vessel. pls find photos for your reference.
 
Shell material  is SA 36. thickness 8mm. service fluid - water
 
Code of construction is ASME SEC VIII DIV1
 
After grindings also pittings can be observed on the large surface of the shell.
 
Whether these pittings can be accepted as it is OR further grinding is required.
 
Please Suggest.
 
Thanks and Regards
 
Asad Azmi

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.



--
Thanks  & Best Regards,

Suresh

Mobile No: 91-92 92 905 905

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

No comments:

[MW:34820] RE: 34813] Clarification in Rate of heating and cooling.

Hello,   Please see the response below.   Regards.   P. Goswami, P. Eng, IWE.   From: materials-welding@googlegroups.com <materials-weld...