Dear Limesh,
Just see clause 452.3 in ASME Sec.IX, there are Diameter restrictions, you have qualified your welder in 1 1/2 " Pipe means he falls in 1"(25mm) to 2 7/8"(73mm) restriction, which says Welder can weld from 1" to unlimited, but now for his renewal you are supporting 8" pipe, So asthetically it is not possible, he may fall in over 2 7/8" ( ie 73mm to unlimited), So better to show RTs of 1 1/2" or less than 2 7/8" Pipe . So that he can regain his qualification subject to his contuity record.
On Sat, May 28, 2011 at 6:29 PM, limesh M <limesh78@gmail.com> wrote:
Dear All,--Welder Qualification Code: ASME BPV SEC IXI have a qualified welder with following diameter range.1.1/2'' and aboveNow his qualification is going to expire and I would like to renew it by showing supporting radiography reports.Is it possible to renew the above qualification by showing the radiography report of an 8" diameter pipe?Regards,Limesh
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
No comments:
Post a Comment