A NCR is an opportunity for a corrective action on your process.
In that case to elaborate methods to minimize distortion.
Moque up: simulate the defect (distortion) on a specimen and then repair it.
After then perform tests over an above the usual PQR tests like hardness and micrography
to check if any metallurgical changes will occur on the base metal and on the non removed weld metal.
Dr. G. Dilintas
I&F Regional Technical Manager
Bureau Veritas Piraeus - Greece
Tel: +30 210 40 63 113/4
Fax: +30 210 40 63 118
Tuesday, February 16, 2010
Re: [MW:4331] Re-welding of completed weld joint
Subscribe to:
Post Comments (Atom)
[MW:35346] Cast-iron welding
Any advice for cast iron welding Sent from Yahoo Mail for iPhone
-
Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
-
Definition of buttering from ASME Section IX, QW/QB-492 Definitions: Buttering: the addition of material, by welding, on one or bot...
-
Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...
No comments:
Post a Comment