[MW:2497] Re: excess penetration

Prashant,

Generall it is not specified as excess penetration, but if refer the reinforcement acceptance level that becomes applicable unless & until the contract specification has stated any thing on this.

 

On Sat, Jun 20, 2009 at 11:34 AM, <prashantpan_99@yahoo.co.in> wrote:

Dear friends, In which section acceptance std. for excess penetration is mentioned? As per my knowledge it  shall not be more than 1.6 mm. Pl. reply   PSP

---

Cricket on your mind? Visit the ultimate cricket website. Enter now!
--~--~---------~--~----~------------~-------~--~----~
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
-~----------~----~----~----~------~----~------~--~---