Wednesday, August 25, 2010

[MW:6696] Inpection

Dear All,

 

I would like to find the Advanced NDT - RFT, MFL & IRIS for Tubing Inspection and ET.

 

Somebody can give me about these inspection methods?

 

Thank you & Best regards

 

TRAN VAN VUONG

Deputy Technical Director

HP +84 912 262 085

Email: vuongtv@phateco.com

By -

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

[MW:34916] Applicability of Impact requirement as per ASME B31.3

Dear All, Design code – ASME B31.3, Welding Code- ASME BPVC SEC IX Material  to be used used during Fabrication - SA 333Gr6 (P No.1 G...

  • Materails FAQs
    Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
  • RE: [MW:5585] Buttering of weld joints
    Definition of buttering from ASME Section IX, QW/QB-492 Definitions:   Buttering:  the addition of material, by welding, on one or bot...
  • WELD AND WELDING SYMBOLS
    Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...