Re: [MW:33900] Set On Nozzle - Governing thickness for WPS

Dear 

Please share weld design or figure for weld joint including both pipe

On Thu, 5 Jan 2023, 12:53 pm Chintan Raval, <chintan51@gmail.com> wrote:

Dear Expert,

Kindly advice,

For Pressure Vessel as per ASME Sec 8 Div 1,

Nozzle to Shell full penetration weld of Set on type nozzle, which is the governing thickness for wps selection i.e. thickness of nozzle or thickness of shell or both.

In a typical case,

Nozzle thickness 14 mm, needs to be welded on another nozzle of thickness 250 mm.

WPs available is with 5 mm to 200 mm range.

Is this wps can be used for set on type nozzle as it cover range of nozzle thickness

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CAOdsS43ZLNQgO-s0Am8pQw5bJHg2X8SZBSTaZJXTy0zytLymFA%40mail.gmail.com.

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CAOWr6k-M1_1LXQudovwSNxMMuhYYSCo5Jpjd7EWFLudMJmqNGg%40mail.gmail.com.