Monday, February 26, 2018

[MW:27390] Is recommended for conducting PAUT in lower tickness tube

Dear Experts,

Could you please advise, whether PAUT is recommended lower thickness (Dia 2inch X 4 to 5.5 mm thick).

As i knew that below 6mm not recommended for the PAUT according to ASME Case 2816.  
 
Thanks & Regards, 
K.GANESAN 
By -

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

[MW:35614] Re: SS FILLER

dear , pl check A number and Gas composition use for ss cant be sutibale same % for duplex., u need to qualified with aditional testing of f...

  • Materails FAQs
    Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
  • RE: [MW:5585] Buttering of weld joints
    Definition of buttering from ASME Section IX, QW/QB-492 Definitions:   Buttering:  the addition of material, by welding, on one or bot...
  • WELD AND WELDING SYMBOLS
    Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...