Sunday, February 16, 2014

[MW:20112] Stabilizing Heat Treatment of SS 321

Dear Experts,

In one of our client project spec., it is specified that SS 321 pipes shall be in a stabilized HT condition. Stabilizing HT shall be carried out subsequent to the normal solution annealing. Soaking temp. & holding time for stabilizing HT shall be 900º C & 4 hrs respectively.

My questions are (1) what is the purpose of stabilizing HT (2) This stabilized HT pipe shall be solution annealed after bending in coil form. Is it allowed or again we shall have to carry out stabilized HT after solution annealing? Client Spec. asks for solution annealing HT only after bending in coil form. 

Your prompt response on the above shall be highly appreciated.

Thanks & regards,


C. R. GANDHI
(QCM)
By -

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Re: [MW:35506] WPS for Furnace PWHT

Dear Sir, I am not clear about the question. Is the question is "The welding is done without following a WPS having  PWHT and actually ...

  • Materails FAQs
    Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
  • RE: [MW:5585] Buttering of weld joints
    Definition of buttering from ASME Section IX, QW/QB-492 Definitions:   Buttering:  the addition of material, by welding, on one or bot...
  • WELD AND WELDING SYMBOLS
    Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...