Tuesday, January 26, 2010

[MW:4153] Fillet weld qualification in 2F position for SAW process.



Dear All,

I have a requirement to qualify a welder in 2F position for SAW process.

I have referred the test requirement in QW 542.5 of ASME Sec.IX.

For fillet weld qualification, test coupon thickness is given up to 10 mm only.

For SAW Qualification in 2F, shall i use plate thickness higher than 10mm?

Is there any reference/limitations for plate thickness in Sec.IX?

Pl. provide your valuable suggestions.

regards
P.Rao




--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
By -

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

[MW:35346] Cast-iron welding

Any advice for cast iron welding Sent from Yahoo Mail for iPhone

  • Materails FAQs
    Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
  • RE: [MW:5585] Buttering of weld joints
    Definition of buttering from ASME Section IX, QW/QB-492 Definitions:   Buttering:  the addition of material, by welding, on one or bot...
  • WELD AND WELDING SYMBOLS
    Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...