Dear Vichare..
as per ASME SEC V article 2, the manufacturer shall include the minimum radiographic parameters in the radiography documentation, so as per sec V it has not been mentioned the thickness had to be included in the radiography film identification but it has to be included in documentation(report). kindly look at the the qualified procedure for any such classes for the film identification. if it is in a single report if there are different thickness joints, u can ask them to add the thickness in the radiography report against each joint, or u can ask them to make a single report for each thickness so it will be easy for the interpreter to view the IQI requirements..
Regards
Raju Kandula
On Thu, Dec 22, 2011 at 2:59 PM, Ramchandra vichare <vicharerke@indiatimes.com> wrote:
Dear Experts,
During Interpreting Radiography films at one of my vendor's works, I observed that, there is no identification /indicate thickness of job on film so I rejected the film. As far as generally everyone related field experience persons are know unless identification of thickness on film it is very difficult to know which penetrameter to be used but my vendor is arguing for the same. According to him one of "Level III" person insisit them there is no need to mentioned thickness in Radiography films and it sufficient if it indicate in Radiography interpretion report.
Suppose in piping number of joints/piping spools are comming with verious thickness in same report in such case it is possible to identify required penetrameter ? My anser is no, each Radiography films must be indicat thickness of joint/job. Requested to suggest/advise.
Sincerely yours,
RK Vichare
--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
No comments:
Post a Comment