Wednesday, March 23, 2011

RE: [MW:10460] Pipe range Qualified

None for WPS, and >24” Ф  for WQT in ASME

 

From: materials-welding@googlegroups.com [mailto:materials-welding@googlegroups.com] On Behalf Of Venkateswaran
Sent: Wednesday, March 23, 2011 12:57 PM
To: materials-welding@googlegroups.com
Subject: [MW:10459] Pipe range Qualified

 

Regading the PQR/WPQ,if the welder Qualified in 1G position in 8 mm thck plate full penetration welding,what will be the qualified range in pipe .

 

regards,

kvr


By -

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

[MW:34916] Applicability of Impact requirement as per ASME B31.3

Dear All, Design code – ASME B31.3, Welding Code- ASME BPVC SEC IX Material  to be used used during Fabrication - SA 333Gr6 (P No.1 G...

  • Materails FAQs
    Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
  • RE: [MW:5585] Buttering of weld joints
    Definition of buttering from ASME Section IX, QW/QB-492 Definitions:   Buttering:  the addition of material, by welding, on one or bot...
  • WELD AND WELDING SYMBOLS
    Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...