As I understand that ISO9692-1 is not specifying any root gap for 10mm plate thickness welding.
In that case following is suggested -
The Plate bevel shall be 45-50 Deg Root opening with backing - 6-8 mm
This will have access for full fusion
Thanks
Vishwas -IWE
On Friday, August 11, 2023 at 4:27:03 PM UTC+5:30 Pampanagouda Haraginadoni wrote:
Dear Sir'sCan Anybody clear that for 10mm thickness plates how much root gap with back strip to be made as per ISO9692-1 and in this stanrd showing >16mm but it is 10mm plate so that i m doubt about this.so that can anybody help in this regard
H .PAMPANAGOUDA.PATIL| (CRS&I-SHOP) | Vijayanagar Works | JSW Steel Limited P.O. Vidyanagar | Dist. Bellary | Karnataka-583275 | India Direct : +91 8395 243105 Cellphone: +91 9480694735 Email : pampanagouda...@jsw.in Website: www.jsw.inP Print only when necessary |7 Switch off as you go |qRecycle always#Better Everyday
Confidentiality Notice
The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s) and may contain confidential or privileged information. If you are not the intended recipient, please notify the sender at JSW or System Manager ( ad...@jsw.in ) immediately and destroy all copies of this message and any attachments. Recipients must check this email and its attachments for the presence of viruses before downloading them. JSW Group accepts no liability for any damage caused by any virus transmitted by this email.
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/89da2684-c3fb-47ab-98d5-23cb63b23e36n%40googlegroups.com.
No comments:
Post a Comment