Mr Megnath ,
Kindly clean the joint surface by buffing wheel & then take RT .
It will get cleared
Regards
Anil Hegde
On Sat, May 26, 2012 at 11:57 AM, Megnath <megnath@gmail.com> wrote:
Dear friends,
We are doing welding (GTAW using 99.99% Argon & 70-30 cnsumable) of
CuNi - 90-10 pipe and all of them fall under class 1 pipe and forced
to examine the weld by Radiograpy. On review of radiograph, none of
the joint gets cleared. The only problem with welding is "POROSITY".
As pe our contract, the size of permissible porosity is 0.2t
(thickness of pipe is 3,4mm) and even 1mm porosity calls for repair.
Could any one share your knowledge on the following.
1. Acceptance criteria for RT of CuNi pipe weld
2. How to overcome from the porosity
Best Regards,
Megnath
--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
No comments:
Post a Comment