Tuesday, May 20, 2008

[MW:785] Re: Inch DIA

The term Inch Dia OR Dia Inch is used for the quantity of welding for the piping fabrication.
 
1 inch dia/Dia inch = Size of the joint X No. of the joints.
 
Regds/Jignesh
-----Original Message-----
From: materials-welding@googlegroups.com [mailto:materials-welding@googlegroups.com]On Behalf Of Zameer Mohammed
Sent: Monday, May 19, 2008 6:14 PM
To: materials-welding@googlegroups.com
Subject: ***SPAM*** [MW:784] Inch DIA

Dear Friends,

 

What is the difference between 1 inch welding and 1 inch dia welding?

 

1 inch dia = 1* 3.14 = 3.14 inch. Is this right.

 

One full welding on a 42'' pipe is 42'' dia welding...is it right.

 

Thank you,

 

Regards,

 

Sabir

--~--~---------~--~----~------------~-------~--~----~
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
-~----------~----~----~----~------~----~------~--~---

2 comments:

Unknown said...

What is the difference between 1 inch welding and 1 inch dia welding?

1 inch dia = 1* 3.14 = 3.14 inch.
Answer: this is the circumference of a 1" diameter pipe.

One full welding on a 42"pipe is 42"dia welding.
Answer: this is what you call inch-dia or dia-inch in pipe welding production or pipe erection term

Unknown said...

What is the difference between 1 inch welding and 1 inch dia welding?

1 inch dia = 1* 3.14 = 3.14 inch.

Answer: 3.14 inch in the above calculation is the circumference of a 1" diameter pipe.

One full welding on a 42" pipe is 42" dia welding
Answer: This is the inch-dia that is normally used for measuring a piping job, common in pipe welding production or pipe erection

Re: [MW:34832] Inquiry about Single Bevel with Back Grinding

Dear Uday, As per your question that one is called with backing only,Simple both side you are welding it is backing with strip or without st...