Wednesday, April 10, 2013

[MW:17336] Request to provide filler metal & Flux combination for SAW process for low temperature service with Heat treatment

Dear Experts,

We are going to qualify welding procedure of following details

 

1.       Welding with

·         GTAW with ER70S2

·         SMAW with E7018-1 &

·         SAW

 

2.    Heat treatment after welding at 620°C @ 200min

3.    Impact testing after heat treatment at -46°C

 

Kindly  advise on  filler metal & Flux combination for SAW process to achieve impact properties after heat treatment.

 

Can F7A8 EM12K  will this serve the purpose…!!

 

 

Thanks & regards

 

Ali Mhaskar,
By -

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

[MW:34916] Applicability of Impact requirement as per ASME B31.3

Dear All, Design code – ASME B31.3, Welding Code- ASME BPVC SEC IX Material  to be used used during Fabrication - SA 333Gr6 (P No.1 G...

  • Materails FAQs
    Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
  • RE: [MW:5585] Buttering of weld joints
    Definition of buttering from ASME Section IX, QW/QB-492 Definitions:   Buttering:  the addition of material, by welding, on one or bot...
  • WELD AND WELDING SYMBOLS
    Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...