Re: [MW:11866] Calculation for root gap according to tihckness of pipe

dear abhishek ,

Root gap you can refer from an wps .Generally as per standard the root gap is 3-4 mm max to have full penetration at joint. 

if it is different thickness so you has to go for internal bevelling near id so your thickness get matched .

regards

dinesh

On Fri, Jul 22, 2011 at 2:17 PM, abhishek ojha <abhishekojha_iu@yahoo.co.in> wrote:

Dear Expert, Kindly guide me how to calculate root gap according tihckness of pipe of different /same dia.(different tickness but same dia) Thanks & Regards,   Abhishek Ojha  Engineer- Construction

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.