Please check AWS Handbook Chapter Heat Flow in Welding
There is a Formula for it and by specifying the Peak Temperature as Ac1 temperature, you can determine the width of HAZ
Thanks & Regards
J.Gerald Jayakumar
0091-9344954677
From: Prasad Rode <purode333@gmail.com>
To: Materials & Welding <materials-welding@googlegroups.com>
Sent: Sunday, July 9, 2017 1:46 PM
Subject: Re: [MW:26667] HEAT AFFECTED ZONE CALCULATION
Dear sir,
I didn't know about code reference, but can say that HAz for thin plate is the about fraction of inch. But for thick plate, HAZ will be maximum 10mm.
As said earlier, HAZ depends on several factor like plate thk, process, heat input etc.
Consider haz max. 25mm
Experts, Correct it , if I am wrong.
Regards
Prasad Rode
--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
Visit this group at https://groups.google.com/group/materials-welding.
For more options, visit https://groups.google.com/d/optout.
I didn't know about code reference, but can say that HAz for thin plate is the about fraction of inch. But for thick plate, HAZ will be maximum 10mm.
As said earlier, HAZ depends on several factor like plate thk, process, heat input etc.
Consider haz max. 25mm
Experts, Correct it , if I am wrong.
Regards
Prasad Rode
--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
Visit this group at https://groups.google.com/group/materials-welding.
For more options, visit https://groups.google.com/d/optout.
Comments