Re: [MW:23083] CRACK IN ANGLES , An interesting topic and more interesting issue!

Please see EN 10025-2, 7.5.3. It will refer you to the EN 10163-1 to 3 for permissible surface discontinuity and repair modes.

Regards

On Wed, Jun 17, 2015 at 2:18 AM, Mehdi Vafakhah <mehdi.vafakhah@gmail.com> wrote:

Dear expert,

I'm recently working in a structural project as welding qc . During fabrication inspection, surface crack was found in angles material used in project ( as bracing ) so i reviewed the mechanical examination reports ( the tests are done according to En iso 10025-2 ) but absolutely mechanical properties and chemical analysis is ok! and that is so interesting to me  .

And after that according to the material examination reports, welding of a reinforcing bare is permitted by the engineer and its more interesting issue for me!

However my question is according to any fabrication standard is it possible to welding on a cracked surface material like that ?

(the depth of cracks are 3 mm in both sides and in all over the angles surface area .) 

Thank you.

--
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To post to this group, send email to materials-welding@googlegroups.com.
Visit this group at http://groups.google.com/group/materials-welding.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/58e4afce-c563-45d9-baa3-c7c86243d959%40googlegroups.com.
For more options, visit https://groups.google.com/d/optout.

--

M. Shokri Arfaei

ISA-ISTS - Metallurgy Lab. Manager

ASNT NDT Level III

International Welding Engineer

Tel.: +98 21 66282127

Fax: +98 21 66282779

Mob.:+98 912 1394023

--
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To post to this group, send email to materials-welding@googlegroups.com.
Visit this group at http://groups.google.com/group/materials-welding.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CAC8uMtsBTRmyd%2BE6COMhM3ujuMzT%3DkhcJByAEauYeQx2mO%3DhYg%40mail.gmail.com.
For more options, visit https://groups.google.com/d/optout.