RE: [MW:32634] DENSITY OF RT FILM

Area of interest should be weld and HAZ, density must be acceptable for both areas.

 

From: materials-welding@googlegroups.com [mailto:materials-welding@googlegroups.com] On Behalf Of Muhammad Azeem
Sent: Friday, 03 December 2021 11:14 AM
To: materials-welding@googlegroups.com
Subject: Re: [MW:32633] DENSITY OF RT FILM

 

Hi senthil,

You just need to checked the area of concern weld only. Any defect withing the weld area will be consider as film defect as Reshoot or weld defect in case of reject or accept within limitations. 

 

 

Asme sec V for Non destructive testing. 

 

 

 

On Fri, Dec 3, 2021, 6:14 AM SEN SEN <senins054@gmail.com> wrote:

Dear experts

    while doing film interpretation, which all area need to be checked for density with densitometer? spec says 1.8 to 3.5, is it only for weld area or also for entire area of film? 

 

please clarify with  which code,

thanks with regards,

senthil P

 

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CAGYkEe2ecsSUJVSKCTzo9H59mrMwKFSiMyNz87NHu9Gq3cL3sw%40mail.gmail.com.

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CAHqH7yCu9gGn8KjF%3Dzqh%3DHYk1nmxCNx0QT55GrG1vD6i1GvSVQ%40mail.gmail.com.