Saturday, June 25, 2011

[MW:11467] Minimun thickness requirement to carryout PWHT for CS

Dear All
As per ASME Sec 8,what will be the minimun thickness requirement to carryout  PWHT for CS .Kl.refer me the page no/Table.
 
Regards,
K.Venkateswaran.

zero b footer 

Please consider the environment before printing this E-mail


By -

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Re: [MW:35686] HDPE WPS

Refer ASME SEC IX  There is separate chapter for Plastic welding . Based on that you have to prepare  Sent from my iPhone On 21 Jun 2025, at...

  • Materails FAQs
    Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
  • RE: [MW:5585] Buttering of weld joints
    Definition of buttering from ASME Section IX, QW/QB-492 Definitions:   Buttering:  the addition of material, by welding, on one or bot...
  • WELD AND WELDING SYMBOLS
    Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...