HI
you can refer only to ASME Sec IX for PQR because B31.3 also gives directions, But NDT for piping welds you want to refer to B31.3 based on Category D,or M ... .
On Tue, Feb 27, 2024 at 3:13 PM 'SENTHILKUMAR SWAMINATHAN' via Materials & Welding <materials-welding@googlegroups.com> wrote:
--Hello Dears,Please give you input when PQR for Piping done - Client spec is silent in NDT Acceptance criteria. Which code Acceptance criteria should use for NDT?ASME B31.3 or ASME IX.Thank you,Regards,S.SENTHILKUMAR
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/750277828.828737.1709031941988%40mail.yahoo.com.
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CAEE6DzffbS6xKHz%3DUMq1idrQPVg7zYDpxbo%3DQu0F1okgDE6PRQ%40mail.gmail.com.
No comments:
Post a Comment