Dear Karthikeyan,
Refer your project specification/procedure, which standard to be followed. If nothing is mentioned, refer SSPC PA2. Its describe (Procedure) how you have to measure the DFT.
If the thickness is higher than what it is mentioned in the specification, always refer with coating manufacture/specifier/designer.
Regards,
Pramodh Ramanunny
If We Work With Determination And Perfection, Success Will Follow
On Monday, January 15, 2018, 3:38:35 PM GMT+3, Karthikeyan Muthuvel <m.karthick2020@gmail.com> wrote:
Dear Experts,
I'm very fresh for Painting Inspection, Kindly advise me for following
In the data sheet it is mentioned maximum DFT is 350 microns, when I measured on the piping its shows 1000 microns and above, Please clarify is it acceptable or not which international standards should i follow and what are defect will occur due to the higher thickness of coating.
Looking forward for yours kind valuable feedback.
Thanks & Warm Regards,
KARTHIKEYAN M.
Mobile:+966-501176985,
E-mail: m.karthick2020@gmail.com
P Save A Tree - Please do not print unless really need
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
Visit this group at https://groups.google.com/group/materials-welding.
For more options, visit https://groups.google.com/d/optout.
No comments:
Post a Comment