Dear Experts,
I'm very fresh for Painting Inspection, Kindly advise me for following
In the data sheet it is mentioned maximum DFT is 350 microns, when I measured on the piping its shows 1000 microns and above, Please clarify is it acceptable or not which international standards should i follow and what are defect will occur due to the higher thickness of coating.
Looking forward for yours kind valuable feedback.
Thanks & Warm Regards,
KARTHIKEYAN M.
Mobile:+966-501176985,
E-mail: m.karthick2020@gmail.com
P Save A Tree - Please do not print unless really need
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
Visit this group at https://groups.google.com/group/materials-welding.
For more options, visit https://groups.google.com/d/optout.
No comments:
Post a Comment