Dear Friends,
I got the figure of tensile strengh during mechanical testing of API 5L X52.
The yield strengh is 336 mPa. but API 5L standard requires the yield strengh to be 358 mPa for this type of material. I would like to know if there is any deviaition from 358 mPa which could be accaptable in this case.
I mean what percentage of deviation from standard requirement is acceptable? or it is required a retest. If is there any standard reference explaining these please let me know.
regards,
Elshan.
Hotmail: Powerful Free email with security by Microsoft. Get it now.
Subscribe to:
Post Comments (Atom)
Re: [MW:35686] HDPE WPS
Refer ASME SEC IX There is separate chapter for Plastic welding . Based on that you have to prepare Sent from my iPhone On 21 Jun 2025, at...
-
Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
-
Definition of buttering from ASME Section IX, QW/QB-492 Definitions: Buttering: the addition of material, by welding, on one or bot...
-
Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...
No comments:
Post a Comment