Monday, January 21, 2013

Re: [MW:16556] PWHT TEMP.RANGE IN CODES

Dear friend ,
 
    AS per code if u refer TWI-3.2 swnior welding inspector
 
UCT= Annealing ,Normalising And Hardening
Normally heating 50 degree beyond its A3 or Upeer Critical Temperature then soaked for 1 hour for every 25 mm of thickenss..
 
LCT= Tempering,Stress Relieving and Pre-heating...
 The temperature between 200 degree to 650 degree..

Regards
shankar
Welding Inspector
saudi arabia

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
http://www.linkedin.com/groups/MaterialsWelding-122787?home=&gid=122787&trk=anet_ug_hm
 
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
 
 

No comments:

[MW:34820] RE: 34813] Clarification in Rate of heating and cooling.

Hello,   Please see the response below.   Regards.   P. Goswami, P. Eng, IWE.   From: materials-welding@googlegroups.com <materials-weld...