Tuesday, November 20, 2012

Re: [MW:15982] Re: What kind of weld defect? pl advice..

it is pinhole and must re weld after grainding

Haitham A. Aouda
Inspector Engineer
ASNT LEVEL II RT/PT/MT/VT
AWS-CWI
Basra
Iraq


--- On Tue, 11/20/12, Sathish Kumar <sathishbemech@gmail.com> wrote:

From: Sathish Kumar <sathishbemech@gmail.com>
Subject: [MW:15977] Re: What kind of weld defect? pl advice..
To: materials-welding@googlegroups.com
Date: Tuesday, November 20, 2012, 3:55 AM

Dear Experts,
Thanks for the valuable reply.
Now i am clear that it is a pin hole. (also pl see attach photo).
But as per AWS D1.1 Sec 6 Table 6.1 also doesnot mentioned the acceptance criteria for the pin hole, but only stated about porosity. so how can we justify that pin hole is not acceptable as per what standard or Spec?
Pl advice.
 
thanks & regards
sathish

On Mon, Nov 19, 2012 at 12:41 PM, Sathish Kumar <sathishbemech@gmail.com> wrote:
Dear experts,
pl find attach.
it is a structure welding. fillet weld.
What kind of defect is this? whether this is acceptable or reject as per spec/code. pl specify exact reference.
thanks in advance.
 
sathish
saudi

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
http://www.linkedin.com/groups/MaterialsWelding-122787?home=&gid=122787&trk=anet_ug_hm
 
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
 
 

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
http://www.linkedin.com/groups/MaterialsWelding-122787?home=&gid=122787&trk=anet_ug_hm
 
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
 
 

No comments:

[MW:34820] RE: 34813] Clarification in Rate of heating and cooling.

Hello,   Please see the response below.   Regards.   P. Goswami, P. Eng, IWE.   From: materials-welding@googlegroups.com <materials-weld...