Dear Lalit,
In all P11 materials, it is always advisable to go for a PWHT for all welds.
Thanks and Bets Regards,
K.Rajagopal
On Thu, Jun 7, 2012 at 1:00 PM, LALIT VADADORIYA <lalit.vadadoriya@gmail.com> wrote:
Dear Expert,In case of P11 alloy steel material, if trunnion support thickness is morethen 13mm, in that case PWHT is required or not?
--Regards
Lalit Vadadoriya
Sr.Engineer (Inspection)
Engineers India Limited
Dahej Petrochemical Complex,Dahej (Gujarat)
--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
1 comment:
Dear lalit. WE have done PWHT in P4+P4 group material if thickness 16 mm in case of stub and attachment weld . But in case of piping P4 group to P4 group material thickness of groove/ butt for all thickness PWHT is necessary. Here PWHT is necessary in your case only if attachment thickness is 16 mm and material having carbon % less than 0.15%. If you know the detail please see the ASME SECOND VIII DIV -2 or PWHT -38. P4+P4. Thickness =13mm pre heat - 125 For case of fillet (range 1.6 to12 mm) P4+P4 Thickness =13mm preheat. 150 (range 9mm to 200mm). P4+P4 in case of pipe for all thickness PWHT must. Preheating =150. During Heat treatment HOLDING temp. Is (640 to 670 ) And post heat is NIL. Please note that. Also thease two things as discuss. 1- irrespective of the stub or attachment materials, the PWHT cycle shall be governed by the pipe material.2- throat shall be specified in the drawing wherever flanges are welded to pipes combined throat shall be taken into consideration. Vishwas kumar pathak (QA/QC). JAYPEE GROUP (PPGCL BARA THERMAL 660*5).
Post a Comment