Monday, October 10, 2011

Re: [MW:12648] Orbital Welding - weld joint preparation

Dear Mr. Jignesh
 
yes ,this is required to make 'J' 'U' groove (with No Root gap) preparation for welding of Piping joints by ORBITAL Welding.   because the lip or land thickness(1 to 2mm) of 'J' 'U' groove (with No Root gap) preparation will produce the consistant penetration of weld. and the Orbital Welding M/C head will control the Amps, Volts, Speed, with respect to the position of weld.
 
Thanks  & Regards
Amit Pahuja

Sr. Welding Engineer




On Mon, Oct 10, 2011 at 12:06 PM, Desai Jignesh (Mumbai - Piping) <J.J.Desai@ticb.com> wrote:

Is it mandatory to make 'J' groove preparation for welding of Piping joints by ORBITAL Welding?

 

Regds/Jignesh

 

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

No comments:

[MW:34820] RE: 34813] Clarification in Rate of heating and cooling.

Hello,   Please see the response below.   Regards.   P. Goswami, P. Eng, IWE.   From: materials-welding@googlegroups.com <materials-weld...