Friday, August 19, 2011

Re: [MW:12274] Tube to Tube sheet welds_Minimum Leak Path Measurement _REg.,

Dear Sir (from KCR),
Whould you please clarify which on of below is your requirement?
1 - you like to measure the like path when you do macro test?
2 - you like to know designing parameters for leak path?
 
Regards

On Fri, Aug 19, 2011 at 7:27 AM, kcrtechnical <kcrtechnical@gmail.com> wrote:
Dear all,
 
Can you share with me about minium leak path measurement and its acceptance crietaria as per ASME Section I.
 
Best regards
K C R

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.



--
M.Shokri Arfaei
International Welding Engineer
RT, UT ASNT Level III
ERI-Metallurgy Lab. Manager
Tel: +98 21 66283693
Fax: +98 21 66283693
Mob.: +98 912 139 4023
Web: www.metallurgylab.com

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

No comments:

[MW:34820] RE: 34813] Clarification in Rate of heating and cooling.

Hello,   Please see the response below.   Regards.   P. Goswami, P. Eng, IWE.   From: materials-welding@googlegroups.com <materials-weld...