Friday, May 6, 2011

Re: [MW:10986] WPS

My dear Ramulu,
The date per se is not an essential variable! But any way, you will be in a position to write (or rewrite) an actual WPS only when the PQR qualification falls through. Then the WPS you work out takes in to consideration the ranges of parameters obtained during running of PQR. Please bear in mind that in production welding thereafter, you need to stick as closer to the lower end of these parameters as practicable. To answer your query, the date of the workable WPS will be after that of the PQR qualification only, logically speaking.
Regards,
Shashank Vagal


--- On Sun, 24/4/11, Venkat Ramulu <cvramulu@yahoo.com> wrote:

From: Venkat Ramulu <cvramulu@yahoo.com>
Subject: [MW:10817] WPS
To: "MATIRIAL WELDING" <materials-welding@googlegroups.com>
Date: Sunday, 24 April, 2011, 10:11 AM

Dear friends,
Can any body clarify that to establish a WPS, first we will design(write) a WPS and weld a test coupon according to written WPS, during welding of test coup We note actulal weld parameters  and also test results in PQR.Ofter qualifing PQR,is it required to write WPS using actual parameters again? and what should be the date of WPS,is it date of written WPS or date should be after qualification of PQR?
 
Thanks and best regards,
CV.Ramulu

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

No comments:

[MW:34820] RE: 34813] Clarification in Rate of heating and cooling.

Hello,   Please see the response below.   Regards.   P. Goswami, P. Eng, IWE.   From: materials-welding@googlegroups.com <materials-weld...