Wednesday, March 23, 2011

Re: [MW:10461] Pipe range Qualified

Be explicit what your code is. If you’re talking about ASME sect IX, please going through QW-461.9 which will tell you about qualification test and position qualified.


rgds

2011/3/23 Bathula Raghuram (Mumbai - PIPING) <R.Bathula@ticb.com>

None for WPS, and >24” Ф  for WQT in ASME

 

From: materials-welding@googlegroups.com [mailto:materials-welding@googlegroups.com] On Behalf Of Venkateswaran
Sent: Wednesday, March 23, 2011 12:57 PM
To: materials-welding@googlegroups.com
Subject: [MW:10459] Pipe range Qualified

 

Regading the PQR/WPQ,if the welder Qualified in 1G position in 8 mm thck plate full penetration welding,what will be the qualified range in pipe .

 

regards,

kvr


--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

No comments:

[MW:34820] RE: 34813] Clarification in Rate of heating and cooling.

Hello,   Please see the response below.   Regards.   P. Goswami, P. Eng, IWE.   From: materials-welding@googlegroups.com <materials-weld...