Thursday, March 31, 2011

[MW:10539] Re: Effect of Slope on Projection and Elevation of Nozzle during Pressure Vessel Fabrication

For horizontal vessels with slop following points may be noted.
Saddle supports will be of different height dependinggg slope.
Elevations to be marked from working point on tangent line, generally
on lower side of slope on one end of vessel.
Nozzle facesesshall be parallel to ground.
Vessel horizontal centre line shall be in slope with respect to
ground.
Nozzle projections shall be measured from point on vessel centreline
which is marked from working point.


Regards,
Prassad

Idris Mohiuddin wrote:
> Dear Experts,
>
> Please throw some light on the following query:
>
> :What effect will Slope have on projection & Elevation of Nozzle during
> fabrication of Pressure Vessel (Slope is given as 1.5% in GA Drawing)"
>
> Regards,
>
> MIM

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

No comments:

[MW:34820] RE: 34813] Clarification in Rate of heating and cooling.

Hello,   Please see the response below.   Regards.   P. Goswami, P. Eng, IWE.   From: materials-welding@googlegroups.com <materials-weld...