Wednesday, February 2, 2011

[MW:9687] Supplementary requirement of UT Test comparison in A672

UT1 is more liberal and UT3 is stringent, selection will be by your designer, based on application/design conditions or contract requirements
________________________________________
From: desaid@toyoindia.com [desaid@toyoindia.com]
Sent: Wednesday, February 02, 2011 4:14 AM
To: Bathula Raghuram 
Subject: Supplementary requirement of UT Test comparison in A672

Dear Raghu san,

As my this id is removed from the group; mail won't be delivered. Can you pls. arrange to deliver the same or if possible reply.

Dear All,

In ASTM standard A672 for UT testing of plate, there are three requirements given. UT1, UT2 & UT3.
Our plate thickness is less than 2".
We have to instruct vendor to carry out UT test on plate.
Pls. help us to know which out of these is most critical & which one most liberal. Or criteria to decide which one shall be selected. i.e.  S10, S11 or S12 shall be used?

Kindly help.

Thanks & Regards,
Dhwani Desai
Planning & Piping Dept.



--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

No comments:

Re: [MW:34832] Inquiry about Single Bevel with Back Grinding

Dear Uday, As per your question that one is called with backing only,Simple both side you are welding it is backing with strip or without st...