Monday, January 31, 2011

RE: [MW:9598] Flattening Test for SA 106

Excludes 2”

Refer para  11.1 “For pipe NPS 2 and under a sufficient length of pipe shall stand being bent cold through 90°…………..”

 

 

From: materials-welding@googlegroups.com [mailto:materials-welding@googlegroups.com] On Behalf Of Vino Varghese
Sent: Monday, January 31, 2011 4:24 PM
To: materials-welding@googlegroups.com
Subject: [MW:9597] Flattening Test for SA 106

 

Dear Experts,

 

Refer to Section 12.0(Flattening Test) of SA 106, ASME Sec II Part A.

This Section states that - " For Pipe over NPS 2 a section of pipe not less than........"

 

Question: Does the above Interpretation includes 2" or excludes 2" for the Flattening Test?

Do provide the reference of ASME/ASTM which supports the Interpretation.

 

The MTC recieved does not reflect the Flattening Test.( Material - 2", Sch 80, SA 106 Gr.B for Sour Service)

 

Hope to see as usual co-operation from everyone in Material Group.

 

Thanks & Regards

Vino P Varghese

Doha-Qatar


No comments:

Re: [MW:34832] Inquiry about Single Bevel with Back Grinding

Dear Uday, As per your question that one is called with backing only,Simple both side you are welding it is backing with strip or without st...