Purging is not required when we are doing welding of pad or support.
On Fri, 24 Dec 2010 12:36:00 +0530 wrote
>
Dear all ,
we are facing problem for Stainless steel bad support welding as per wps if wall thickness is less then 6.3 mm purging should be required but some of supports has been welded without purging
Material is A312-TP321 DN 150 SCH 10S
DO have any comments on this issue, for this problem actual purging is required or not
PLZ .write your comments
--
>
To post to this group, send email to materials-welding@googlegroups.com
>
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
>
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
>
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
>
Thanks with Regards From
TUSHAR GOHIL
Mobile No: 9510918745 & 7204626800
 |
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
No comments:
Post a Comment