Thursday, December 2, 2010

[MW:8487] RE: What constitutes a weld repair

What is your product specification?

 

From: materials-welding@googlegroups.com [mailto:materials-welding@googlegroups.com] On Behalf Of Johnson, David
Sent: Thursday, December 02, 2010 4:00 PM
To: materials-welding@googlegroups.com
Subject: [MW:8486] What constitutes a weld repair

 

Please give guidance

 

 

There is a lot of confusion and different interpretations as to what exactly is a weld repair and what exactly is (an upgrade),

Especially when it comes to the Post Weld Heat Treatment.

 

I know what the ASTM says and it is generally 20% of wall thickness etc etc,

But this to me seem to be a very grey area and for someone with limited knowledge such as me it doesn`t really  answer the question,

 

Lets for instance say that you have a casting wall that is 100mm thick that has a defect/porosity, you grind or machine that out 25mm to clear the defect, is that a repair?

 

Lets for instance use the same casting same dimensions this time a machinist makes an error and machines a 25mm hole in the wrong place

Is this an upgrade?

 

Next for surface area welds

 

A casting has severe defects on a face that requires lots of grinding and digging out of the face, it is then welded to replace the removed material and the surface area is 80sq in , is that a weld repair?

 

An exact casting has been checked and for whatever reason is short of material for machining, it is then welded to size, the material and the surface is calculated to be 80sq in , is this an upgrade??

 

To me it seems  the ASTM can almost be read to suit , this doesn`t really give a definitive answer, I know that there are different materials that require PWHT but generally the materials that we use all have this section on the specs ,

 

Please give guidance

 

 

 

Regards

 

Dave j

 


__CONFIDENTIAL:

Clyde Union DB Limited
Incorporated in England & Wales – Number 331925
Registered Office – Green Road, Penistone, Sheffield S36 6BJ, England

The information contained in this email (including any attachments) is confidential, subject to copyright and for the use of the intended recipient only. If you are not the intended recipient please delete this message after notifying the sender. Unauthorised retention, alteration or distribution of this email is forbidden and may be actionable.

Attachments are opened at your own risk and you are advised to scan incoming email for viruses before opening any attached files. We give no guarantee that any communication is virus-free and accept no responsibility for virus contamination or other system loss or damage of any kind.

.


No comments:

Re: [MW:34832] Inquiry about Single Bevel with Back Grinding

Dear Uday, As per your question that one is called with backing only,Simple both side you are welding it is backing with strip or without st...