Monday, October 25, 2010

Re: [MW:7774] ASME BPV SEC IX Material Range issue

Dear Limesh,
 
My interpretation with QW-403.5 as Below.
 

1. Is there any problem for welding P1 Group No.1 to P1 Group No.1  &  P1 Group No.2 to P1 Group No.2 based on above PQR?

You Cannot write WPS for the above combinations with existing PQR.

.2.Can I write separate WPS (with impact test) based on above PQR for,

Material – P1 Group No. 1 to P1 Group No. 1

Material – P2 Group No. 2 to P2 Group No. 2

 
However, if you have the PQR Qualifications for the P1 Group No. 1 to P1 Group No. 1 & P1 Group No. 2 to P1 Group No. 2 combinations with same essential, non-essential variables,
 
Then you can write the WPS for  the P1G1 to P1 G2 , with qualifying P1G1 to P1G2  materials.
 
 
Thanks & Regards
 
K.Babu
Singapore
 
 
 
----- Original Message -----
From: limesh M
Sent: Sunday, October 24, 2010 10:42 PM
Subject: [MW:7767] ASME BPV SEC IX Material Range issue

Dear All,

 

I need your help in the following subject.
 

Design Code – ASME B31.3

Welding Code – ASME BPV SECTION IX

I have a PQR for the following material classification as per ASME BPV SEC IX

Material – P1 Group No. 1 to P1 Group No. 2

Weld Metal Impact Tested – Yes

 

My query is that,

1. Is there any problem for welding P1 Group No.1 to P1 Group No.1  &  P1 Group No.2 to P1 Group No.2 based on above PQR?

2.  Can I write separate WPS (with impact test) based on above PQR for,

Material – P1 Group No. 1 to P1 Group No. 1

Material – P2 Group No. 2 to P2 Group No. 2

 

My next query is that,

Is there any problem for showing all material range in a single WPS based on above PQR?

Ie, qualified range of materials- P1 Group No. 1 & P1 Group No. 2 in the same WPS.
 
 
Regards,
 
Limesh

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

No comments:

Re: [MW:34832] Inquiry about Single Bevel with Back Grinding

Dear Uday, As per your question that one is called with backing only,Simple both side you are welding it is backing with strip or without st...