Wednesday, October 13, 2010

[MW:7531] RE: 7526] x-ray in the shop

You can use X-ray below 8mm successfully and for sure you will get better
image quality when compared with Ir.

D2, D4 , D4, D7 are film trade names of Company Agfa indicating diffrent
film speeds. D2 being the slowest (better resolution) and D7 being the
fastest (poor resolution).

Regards

Serdar

-----Original Message-----
From: materials-welding@googlegroups.com
[mailto:materials-welding@googlegroups.com] On Behalf Of Brl Pp
Sent: Wednesday, October 13, 2010 7:33 AM
To: Materials & Welding
Subject: [MW:7526] x-ray in the shop

good morning,

can I use X- ray for below 8mm class IV caron steel and stainless
steel piping in the shop?

what means AGFA D5, AGFA D4/D2?

please shar your exerience

my regards

redouane

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to
materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at
http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and
meant for educational purposes only, Users must take their own decisions
w.r.t. applicable code/standard/contract documents.

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

No comments:

Re: [MW:34832] Inquiry about Single Bevel with Back Grinding

Dear Uday, As per your question that one is called with backing only,Simple both side you are welding it is backing with strip or without st...