Thursday, September 16, 2010

[MW:7026] PWHT and Welding requirement of Carbon steel to P22

Dear All,

Kindly suggest your valuable suggestions for following:

1.       Welding consumables for welding of P22 to Carbon steel and why?

2.       PWHT requirement.

3.       The wall thickness of tubes and pipe is from 10mm to 35mm

 

Regards

 

Naveen Kumar

 

 

By -

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Re: [MW:34874] ASME IX, groove weld during WQT limits for Fillet Weld production

Hi David,  There are two points in WQT. 1. Thickness of Base Metal -T 2. Thickness of Weld Metal -t When you use a combination of two proces...

  • Materails FAQs
    Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
  • RE: [MW:5585] Buttering of weld joints
    Definition of buttering from ASME Section IX, QW/QB-492 Definitions:   Buttering:  the addition of material, by welding, on one or bot...
  • WELD AND WELDING SYMBOLS
    Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...