Tuesday, August 17, 2010

Re: [MW:6544] Image quality indicator (IQI) selction for disimilar materials

May this help you S.Das.
 
Regards,
S.SENTHILKUMAR



From: Kam Raj <kamsndt@gmail.com>
To: materials-welding@googlegroups.com
Sent: Tue, 17 August, 2010 5:58:46 AM
Subject: Re: [MW:6534] Image quality indicator (IQI) selction for disimilar materials

Hi,

For IQI (Penetrameter) selection you have choose 2 % of job thickness. In IQI we have ASTM hole type and DIN wire Type.

You can select ASTM hole type designation is 10 or 12 size.
For Wire type you can select set III. (Here we have three sets Like SET 1, SET II, SET III).

Regards

Kamaraj
Aurotech Inspection Services.,
EMail: aurotechin@gmail.com
Trichy



On Mon, Aug 16, 2010 at 1:35 PM, Bathula Raghuram (Mumbai - PIPING) <R.Bathula@ticb.com> wrote:

It should be penetrameter, and the term penetrameter no longer used in Article 2 of ASME Section V now it is being referred as image quality indicator (IQI). You can select the IQI material from the less radiation absorbing material out of this two (material group 1, CS or SS will do).


From: materials-welding@googlegroups.com [mailto:materials-welding@googlegroups.com] On Behalf Of subrata das
Sent: Monday, August 16, 2010 12:59 PM
To: materials-welding@googlegroups.com
Subject: [MW:6511] Pentameter selection

Dear All

What type of Pentameter should i use during Radiography Test of a butt weld joint of 50 mm diameter & 12 mm thickness and joint between A182 F91(WN Flange) to SB622 UNS N10276(Pipe).

 

Regards

Subrata Das

 


--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.



--
Kamaraj. M
Aurotech Inspection Services.,
#22/1A, 8th Cross East,
Thillai Nagar, Trichy 620 018.
Tamil Nadu, India.
Email: kamsndt@gmail.com
Phone: +91 431 4023723
Mobile: +91 98415 52523
www.aurotech.co.in

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

No comments:

[MW:34820] RE: 34813] Clarification in Rate of heating and cooling.

Hello,   Please see the response below.   Regards.   P. Goswami, P. Eng, IWE.   From: materials-welding@googlegroups.com <materials-weld...