Thursday, June 10, 2010

Re: [MW:5510] Gasket for Hydrotest

Hii,
 
test pressure is 180 Bar so you must be use spiral wound gasket only ,Rubber gasket not at all advicable.
 
Please keep on eye on safety .Safey first .
 
Regards
 
Suresh
 
QA/QC
 
Qatar

 
On 6/10/10, A D <alouis1972@yahoo.co.in> wrote:
Hi,
         Spiral wound gasket is safety, other wise un safe if you are use rubber material.
 
The same time you will check with your gasket supplier any metallic gasket ia available for this pressure rating.
 
Louis
 


From: Vijay <k.vijayaraj@gmail.com>
To: Materials & Welding <materials-welding@googlegroups.com>
Sent: Thu, 10 June, 2010 12:56:42 PM
Subject: [MW:5508] Gasket for Hydrotest

Dear All,

We are going to carry out Hydro test for spools at 180 Bar.

What type gasket we should use ? Is it necessary to use Spiral Wound
Gasket for Hydrotest?

Can we use any rubber material ??

Kindly clarify.

Thanks in advance.

Regards,
Vijay.

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

 

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.



--
Thanks  & Best Regards,

Suresh

Mobile No: 91-92 92 905 905

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

No comments:

Re: [MW:34832] Inquiry about Single Bevel with Back Grinding

Dear Uday, As per your question that one is called with backing only,Simple both side you are welding it is backing with strip or without st...