Friday, May 28, 2010

[MW:5281] ASME SEC VIII

Dear all
i have some general informations about this division.
1-I have a material identified fully, also certificate of it is available completly.but it's not in ARTICLE 23 OF ASME secVIII,DIVISION1. can i soppose it  approved according to DIV1,if the  chemical & mechanical properties are in acceptable range based on a permitted specification in SEC II. 
2-in wich code case illustrated a route for getting a approval for a nonapproved material?(except appendix 5 of sec II,part D)
3-what is the meaning of blow in cold forming (UCS 79)? forming with explosion is permitted or not?
4- does anybody have informations about forming methods? how can i get details about forming & forging methods?
5-does anyone have list of articles that related to inspection,testing,examination?
regard advance
 

No comments:

Re: [MW:34832] Inquiry about Single Bevel with Back Grinding

Dear Uday, As per your question that one is called with backing only,Simple both side you are welding it is backing with strip or without st...