Monday, April 19, 2010

Re: [MW:4881] Acceptability of MTC.

Dear Mohan,
                     Consider that as a Impurity,and check your service conditions will accept that Impurities are not?according to that requirements proceed further.
with regards,
B.JAWAHAR,


--- On Sun, 4/18/10, smruthi mohan <smruthi2007@rediffmail.com> wrote:

From: smruthi mohan <smruthi2007@rediffmail.com>
Subject: [MW:4854] Acceptability of MTC.
To: materials-welding@googlegroups.com
Date: Sunday, April 18, 2010, 7:29 PM

Hi.

Anybody please advise me on the below,

we have an 12" End Cap (SA403 WP316L)for an ASME job. But in test certificate there is an additional element content (Cu (0,370))is present in the chemical Analysis. please advice me that we can accept this item or not.

Thanks in advance.

SMRUTHI MOHAN
ENGINEER - MATERIALS.
QICL, FUJAIRAH

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

No comments:

Re: [MW:34832] Inquiry about Single Bevel with Back Grinding

Dear Uday, As per your question that one is called with backing only,Simple both side you are welding it is backing with strip or without st...