Saturday, February 13, 2010

Re: Re: [MW:4305] WPS


Hi friends
Depending on the code used as a reference for the qualification of the WPS. For ASME Section IX jejemplo not limit how the product (plate, pipe, etc..) qualification for welding.


Kind regards
Gustavo Mendoza.

feb 9, 2010 10:50:08 PM, materials-welding@googlegroups.com wrote:

===========================================


However this is not a code requirement (asme section I, VIII-1 etc)


  From: narasimha murthy [jnm71269@gmail.com]
  Sent: 08/02/2010 22:17 ZE3
  To: materials-welding@googlegroups.com
  Subject: Re: [MW:4249] WPS


Hi,As most of the fittings (flanges) used are forged, and since hardness is one of the important factor to be considered during welding, and there are chances that hardness on the heat effected zone of the fittings may be higher than the required values. Hence inorder to monitor the hardness values and ensure that welding procedure qualification qualifies for the fittings Too, It is prefered to weld a welding procedure qualification between pipe to flange. 
Regards J.N.MurthyDoha
On Mon, Feb 8, 2010 at 9:34 AM, krishna wiqw@rediffmail.com> wrote:

Hi all,
              Could one clarify the reason behind using pipe to flange for qualifcation of a welding procedure.
Why pipe to pipe is not used?

thanx
wi



--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.



--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.


--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

No comments:

Re: [MW:34832] Inquiry about Single Bevel with Back Grinding

Dear Uday, As per your question that one is called with backing only,Simple both side you are welding it is backing with strip or without st...