Wednesday, January 20, 2010

RE: [MW:4101] composition manganese less than requirment of ASTM A36

Dear All and Louis,

 

Thank you very much.

 

I would like to study “wet analysis method”. Do somebody know this ?

 

Please advice.

 

TRAN VAN VUONG

 


From: materials-welding@googlegroups.com [mailto:materials-welding@googlegroups.com] On Behalf Of A D
Sent: Wednesday, January 20, 2010 8:14 AM
To: materials-welding@googlegroups.com
Subject: Re: [MW:4096] composition manganese less than requirment of ASTM A36

 

Hi,

     PMI values are not exact value, so the below value of Mn is not a major problem. If you want confirm the correct value, select the wet analaysis method.

 

Louis

Welding Inspector

Singapore

--- On Tue, 19/1/10, babu k <kbabupsg@gmail.com> wrote:


From: babu k <kbabupsg@gmail.com>
Subject: Re: [MW:4092] composition manganese less than requirment of ASTM A36
To: materials-welding@googlegroups.com
Date: Tuesday, 19 January, 2010, 7:44 PM

Hi,

 

The reduction in Mn may be compensated by Carbon content,

 

Also the exact Mn content value u can cross check with wet analysis.

 

 

 

 

On Mon, Jan 18, 2010 at 11:52 AM, Tran Van Vuong <vuong.tv@gmail.com> wrote:

Dear All,

 

Please help me in PMI testing for material ASTM A36 thickness over 20.0mm, the composition requirement of manganese is (0.8 – 1.2)%. But result of test is less than 0.8%. Other testings are accepted (tensile, bending, elongation).

 

Please advice me this result is accepted or not.

 

If not, please advice the solution.

 

Thank you in advance.

 

TRAN VAN VUONG


--
To post to this group, send email to
materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.





Thanks & regards,

K.Babu
Singapore

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.




The INTERNET now has a personality. YOURS! See your Yahoo! Homepage.

No comments:

Re: [MW:34832] Inquiry about Single Bevel with Back Grinding

Dear Uday, As per your question that one is called with backing only,Simple both side you are welding it is backing with strip or without st...