What could be the best ground to convince customer regarding use of
SA106GRB pipe in lieu of API5LGRB PSL1 on sizes 8"NB and above whereby
you may not get 'dual' stencilling on Pipe and 'dual'certifiaction on
a certificate?Since there is absolutely no difference in Mechanical
properties of these two grades and 'chemical' check test of SA106GRB
shall certainly meet requirements of API5LGRB what could be the hitch?
Regards
Aarpee
Subscribe to:
Post Comments (Atom)
Re: [MW:34832] Inquiry about Single Bevel with Back Grinding
Dear Uday, As per your question that one is called with backing only,Simple both side you are welding it is backing with strip or without st...
-
Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
-
Definition of buttering from ASME Section IX, QW/QB-492 Definitions: Buttering: the addition of material, by welding, on one or bot...
-
Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...
No comments:
Post a Comment