Monday, January 18, 2010

[MW:4073] RE: 4072] composition manganese less than requirment of ASTM A36

January 18, 2010

 

Hello Tran!

 

You did not mention the value that you are getting but only indicated that it is lesser than the lower limit. If all other tests are OK, then you need to discuss the matter with your customer for a concession so that it will be accepted.

 

Thanks.

 

PJA

 

SAVE TREES  - THINK BEFORE YOU PRINT


From: materials-welding@googlegroups.com [mailto:materials-welding@googlegroups.com] On Behalf Of Tran Van Vuong
Sent: Monday, January 18, 2010 6:53 AM
To: materials-welding@googlegroups.com
Subject: [MW:4072] composition manganese less than requirment of ASTM A36
Importance: High

 

Dear All,

 

Please help me in PMI testing for material ASTM A36 thickness over 20.0mm, the composition requirement of manganese is (0.8 – 1.2)%. But result of test is less than 0.8%. Other testings are accepted (tensile, bending, elongation).

 

Please advice me this result is accepted or not.

 

If not, please advice the solution.

 

Thank you in advance.

 

TRAN VAN VUONG

No comments:

Re: [MW:34832] Inquiry about Single Bevel with Back Grinding

Dear Uday, As per your question that one is called with backing only,Simple both side you are welding it is backing with strip or without st...