Friday, April 17, 2009

[MW:1970] Re: WELDER QUALIFICATION

This is correct that the welder can weld on all of these materials but do not ignore the other variables. For example the welder will be restricted to the Fnumber filler material he qualified with. An example is a SMAW qualification. When a welder qualifies on P1 material with a matching F4 SMAW filler he will be qualified to the base material range stated below and with F1-F4 carbon steel filler material. This will not qualify him to weld with F5 stainless steel filler material which is needed to weld with matching filler on P8 materials. The same concept will apply to various other P numberd materials. To fully understand this concept and the other variables that will restrict a welders qualifications, read article 3 and QW-416 in ASME Section 9

Regards,

Dale Jones

--- On Thu, 4/16/09, Muhammed Ibrahim <ibratech@gmail.com> wrote:

From: Muhammed Ibrahim <ibratech@gmail.com>
Subject: [MW:1968] Re: WELDER QUALIFICATION
To: materials-welding@googlegroups.com
Date: Thursday, April 16, 2009, 5:45 AM

 
 
Not only P11. Also P34 & P41 thru P49. The reason is, the skill of the welder required to weld any of these material is same. So he can proove it in any one P No. mentioned .
 
Regards,
Muhammed Ibrahim

 
2009/4/16 gaurav mongia <er.gauravmongia@gmail.com>

IF A WELDER IS QUALIFIED FOR P1 material and in code it is written
that he is qualified upto P11.

i wanna know what will be reason that a welder can do welding on all
material upto P11 instead he is only qualified in P1








--~--~---------~--~----~------------~-------~--~----~
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
-~----------~----~----~----~------~----~------~--~---

By -

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

[MW:34916] Applicability of Impact requirement as per ASME B31.3

Dear All, Design code – ASME B31.3, Welding Code- ASME BPVC SEC IX Material  to be used used during Fabrication - SA 333Gr6 (P No.1 G...

  • Materails FAQs
    Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
  • RE: [MW:5585] Buttering of weld joints
    Definition of buttering from ASME Section IX, QW/QB-492 Definitions:   Buttering:  the addition of material, by welding, on one or bot...
  • WELD AND WELDING SYMBOLS
    Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...