Thursday, April 9, 2009

[MW:1902] RE: 1901] Grinding of the weld reinforcement during AUT.

It required to grind not as per code but for correct interpretation , and to move  probe on weld smoothly

 

Hegde

 

From: materials-welding@googlegroups.com [mailto:materials-welding@googlegroups.com] On Behalf Of Snehkumar
Sent: Thursday, April 09, 2009 9:44 AM
To: materials-welding@googlegroups.com
Subject: [MW:1901] Grinding of the weld reinforcement during AUT.

 

In performing Auto UT (Phased Array UT), is it necessary to grind off the weld reinforcement to the level of parent material in Pipe to Elbow joint. If it is necessary then in which code it is mentioned.

And if weld reinforcement is grinded off will it affect the properties of the weld joint.

 

Snehkumar L Mahuri

 

 

 


"This Message and its contents is intended solely for the addressee and is proprietary.Information in this mail is for L&T Business Usage only. Any Use to other than the addressee is misuse and infringement to Proprietorship of L&T ECC.If you are not the addressee please return the mail to the sender.L&T ECC DIVISION"

 


--~--~---------~--~----~------------~-------~--~----~
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
-~----------~----~----~----~------~----~------~--~---

No comments:

Re: [MW:34913] Filler wire

E71T-1C  is Charpy Impact tested at -20degC E71T-1CJ is Charpy impact tested at -40degC. AWS Classification for FCAW is only a supplementary...