Wednesday, March 11, 2009

[MW:1747] Re: Use of 316L for steam service

Please indicate the steam pressure and temperature... Also, the frequency
of use... At a glance, the material can be used but for further analysis,
more info is needed.
B36.19M and B36.10M.
For large bore SS pipes, you can specify thickness from 36.10M, based on
your requirement.
You can refer or use "ASME B31.3 Calculator" at
www.cheresources.com/software.shtml.

Kind Regards,
Bibek Bhattacharyya.


"Faigal Fernando
Agbanawag"
<faigal.agbanawag To
@czfp.com> <materials-welding@googlegroups.com
Sent by: >
materials-welding cc
@googlegroups.com
Subject
[MW:1746] Use of 316L for steam
03/11/2009 03:01 service
PM


Please respond to
materials-welding
@googlegroups.com


Dear All,

Can anybody please tell me if 316L for steam service is tolerable or not.
Is there any reference in B36.19M with regards to this criterion or in any
industry codes.

Thanking you all in advance.


Faigal Fernando Agbanawag
Sr. Piping Engineer
Clough ZFP



T +966 3 8828818 Ext: 241

F +966 3 8828622

M +966 (0) 507780576


Disclaimer: This email and any files transmitted with it are confidential
and intended solely for the use of the addressee(s) named herein. If you
are not the intended recipient or addressee, you should not use,
disseminate, distribute, copy or alter this email. Any views or opinions
presented in this email are solely those of the author and might not
represent those of "CZFP".


Warning: Although reasonable precautions have been taken to ensure no
viruses are present in this email, "CZFP" cannot accept responsibility for
any loss or damage arising from the use of this email or attachments. If
you have received this electronic mail message in error, please contact the
sender directly.


--~--~---------~--~----~------------~-------~--~----~
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
-~----------~----~----~----~------~----~------~--~---

No comments:

Re: [MW:34832] Inquiry about Single Bevel with Back Grinding

Dear Uday, As per your question that one is called with backing only,Simple both side you are welding it is backing with strip or without st...